Datasheet4U Logo Datasheet4U.com

SN74LVTH125-EP - 3.3-V ABT QUADRUPLE BUS BUFFER

Datasheet Summary

Description

This bus buffer is designed specifically for low-voltage (3.3-V) VCC operation, but with the capability to provide a TTL interface to a 5-V system environment.

Features

  • independent line drivers with 3-state outputs. Each output is in the high-impedance state when the associated output-enable (OE) input is high. Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended. When VCC is between 0 and 1.5 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 1.5 V, OE should be tied to VCC th.

📥 Download Datasheet

Datasheet preview – SN74LVTH125-EP

Datasheet Details

Part number SN74LVTH125-EP
Manufacturer Texas Instruments
File Size 678.73 KB
Description 3.3-V ABT QUADRUPLE BUS BUFFER
Datasheet download datasheet SN74LVTH125-EP Datasheet
Additional preview pages of the SN74LVTH125-EP datasheet.

📁 Similar Datasheet

  • SN74LVC1G125 - high performance non-inverting buffer (UMW)
  • SN74LVC1G34 - Single buffer (UMW)
  • SN74L71 - AND-Gate R-S Master-Slave F-F (National Semiconductor)
  • SN74L74N - Dual D-Type Flip-Flop (ETC)
  • SN74LS00 - QUAD 2-INPUT NAND GATE (Motorola)
  • SN74LS00 - Quad 2-Input NAND Gate (ON Semiconductor)
  • SN74LS02 - QUAD 2-INPUT NOR GATE (Motorola)
  • SN74LS02 - QUAD 2-INPUT NOR GATE (ON Semiconductor)
  • SN74LS04 - Hex Inverter (ON Semiconductor)
  • SN74LS04 - HEX INVERTER (Motorola)
Other Datasheets by Texas Instruments

Full PDF Text Transcription

Click to expand full text
D Controlled Baseline − One Assembly/Test Site, One Fabrication Site D Enhanced Diminishing Manufacturing Sources (DMS) Support D Enhanced Product-Change Notification D Qualification Pedigree† D Supports Mixed-Mode Signal Operation (5-V Input and Output Voltages With 3.3-V VCC) D Supports Unregulated Battery Operation Down to 2.7 V D Typical VOLP (Output Ground Bounce) <0.8 V at VCC = 3.3 V, TA = 25°C † Component qualification in accordance with JEDEC and industry standards to ensure reliable operation over an extended temperature range. This includes, but is not limited to, Highly Accelerated Stress Test (HAST) or biased 85/85, temperature cycle, autoclave or unbiased HAST, electromigration, bond intermetallic life, and mold compound life.
Published: |